Refrigerator fault analysis and treatment methods
2024-06-20
With the improvement of the economy and the level of consumption of the population, the use of cold cabinets, cold storage is also more and more widely used, especially for the use of cold cabinets more and more demand, but in the course of our daily use, more or less will appear to use the faults, mostly due to our operation is not standardized, the daily maintenance is not in place caused by, the following will introduce you to a few common faults and processing solutions: not refrigeration can be divided into the following three kinds of Situation:
(1) the compressor starts frequently: the power supply voltage is too high, it should be immediately shut down, until the power supply voltage returns to normal and then reboot, start the compressor, to see if it returns to normal, if it still does not work properly can contact the relevant after-sales service personnel to overhaul the door;;.
(2) indicator light normal light, but the compressor does not work, issued by the "buzz" current sound, should be immediately shut down, if the local voltage fluctuation range often exceeds the prescribed range, unstable, the need to install the AC voltage regulator, to be the power supply voltage to return to normal, in the restart, check the effect.
(3) freezer evaporator surface without frost, the compressor runs for a long time: pipeline damage leakage, refrigerant leakage, need to contact a professional after-sales personnel overhaul.
(4) evaporator surface frost, the compressor runs non-stop:
① refrigerator switch too many times; ② placed in a position that does not leave enough time for the compressor to run.
② placed in a position that does not leave enough ventilation, cooling position or dust and other impurities attached to it, resulting in poor ventilation, cooling effect; ③ temperature controller failure or
③ temperature regulator controller failure or temperature sensing package from the evaporator, resulting in evaporator frost.
Treatment: defrosting should be carried out in a timely manner to clean up the condenser and compressor dust and other impurities, the freezer should be left enough around the location, can not be close to the wall; if the thermostat malfunction or temperature sensing package out of the problem, you need to let the after-sales master for overhaul or replacement.
(5) the compressor does not work:
① if the power indicator does not light, is the power fuse blown, must replace the fuse; ② indicator light normal light, is the power fuse blown, must replace the fuse.
② indicator light normal light, is the controller line failure, you need to contact a professional maintenance master door-to-door inspection and repair; ③ temperature controller weak ambient temperature, the temperature of the controller, the temperature of the controller, the temperature of the controller, the temperature of the controller.
③ temperature controller weak file ambient temperature is too low, adjust the temperature appropriately.
OTHERS
2024
06-20